VJ-1604 Maintenance Manual
5.7.2
Skew Check Menu
Feed the paper to check the skew size using sensor.
When you select this item from the Adjustment Menu, the plotter feeds the loaded media by one pass and
checks difference of the media edge positions before and after the media feed detected by the sensor.
Before performing skew check, ensure that the media is set correctly.
The plotter determines the media setting reference position during first detection of media left edge.
Therefore, the media that is not set correctly may cause errors as below.
• Media error occurs during skew check and plotter operation stops.
• During media initial operation after power is turned on, "Undefined Paper" frequently occurs.
Roll media
[Enter]
[Enter]
[Enter]
Media set
Finish media initialization
Media edge detection finishes normaly
Table 5-6 Skew Amount Specification
Condition
7 m
2.5 mm or less
5-27
5 Self-Diagnosis Mode
0.1 m increments
0.1 m to 10.0 m
If media is not set
Specification
Rev.-05