Side Margin Adjustment Menu - MUTOH ValueJet 1604 Service Manual

5 Self-Diagnosis Mode
(The following shows a case for "Bi-D 240 - Setup" is selected.)
[>] key
[>] key
The initial value is set to values that are suited for the manufacturer genuine ink.
5.7.6

Side Margin Adjustment Menu

This menu is used to adjust the printing margins.
To adjust the margins, follow the steps below.
1. Set media as necessary.
2. After media is set, the detected width of the set media is displayed.
3. After media is set, the plotter prints out band feed correction adjustment patterns and cuts the media in
the following modes.
• Black, 1 pass, Uni-D, 360 dpi
* If "check" is selected, black replaces magenta.
4. Check the printed side margin adjustment patterns for the measurement.
1: Side margin
2: Media feed direction
Rev.-05
[<] key Press [Setting/Value+] or [Setting/Value-] key
to change unit to pulse
1 pulse = 1/2880 inch
[<] key
Pulse range: -400
5-40
VJ-1604 Maintenance Manual
400
Back to Uni D/Bi-D Top menu
2
1