MUTOH ValueJet 1604 Service Manual page 327

VJ-1604 Maintenance Manual
While the LCD display is in the Erasing to Comparing status, the [Power] key is disabled. In
this situation, never disconnect the plug of the plotter. Doing so may disable plotter startup,
which will require reinstallation with special jig.
3. If the LCD displays [transfer complete], the
buzzer sounds three times and only the Power
LED turns on among all LEDs.
× × × × × ×
4. When [ bytes recv (
displayed, installation completes.
Turn off the plotter and restart it. Then check the
version number displayed on the LCD.
If an error occurs during installation, the buzzer sounds at intervals of 0.25 second, while the LCD
displays error message and all LEDs of Roll, Sheet, Color and Black & white flash. In this case,
follow the troubleshooting instructions. To stop the buzzer, press any key except for the [Power] key
once. Pressing the key once again will return the LCD display to "waiting for command" and only
the Power LED on.
× ×
is numeric)] is
7-21
7 Adjustment
Rev.-05