MUTOH ValueJet 1604 Service Manual page 259

VJ-1604 Maintenance Manual
Enter parameters when Bi-D is selected as follows.
(The following shows a case for Bi-D 240.)
• The following shows a case for "Print" (or Print 1 / Print 2) is selected.
* Common for Bi-D, Uni-D
Back to Uni-D/Bi-D top menu
• The following shows a case for "Set up" is selected (Uni-D 240).
Enter parameters when Uni-D is selected as follows.
[>] key
[>] key
[>] key
[>] key
[>] key
[>] key
[>] key
[>] key
[<] key
[<] key
[<] key
Media set
Change head gap (to Low)
Finish printing
[<] key
[<] key
[<] key
[<] key
[<] key
[<] key
[<] key
[<] key
5-39
[>] key
[>] key
[>] key
or select "Print2"
If media is not set
If head gap is PG-High
If the temperature of the preheater and
platen heater is below 42 C
* Pressing [Cancel] key stops control and start printing
Displayed during adjustment printing
* Press [Setting/Value+] or [Setting/Value-] key
to change the setting value.
1 pulse = 1/720 inch
Pulse range: -100 100
* "#2 A" is not displayed because the position is
referred as the basis when adjusting.
* "#2" is displayed if High menu is selected.
Also, "240B" or "320B" is displayed
according to the mode selection.
[Enter] key
Returns to "Uni-D 240" setup menu
5 Self-Diagnosis Mode
Rev.-05