MUTOH ValueJet 1604 Service Manual page 432

9 Troubleshooting
Table 9-13 Problems in Using Dedicated Network Software (Continued)
No. Event/symptom
3 "Error received: Buffer
overflow." is displayed
during transfer.
4 The "Transfer failed
incompatible F/W" error
message is still displayed
though the proper
firmware is being
transferred.
Rev.-05
Check item
Firmware size is too large.
Check if transferred
firmware is an appropriate
file.
This is a main board that
has firmware from a
different model installed to
it. Check the DIP switch
settings on the main board.
9-70
VJ-1604 Maintenance Manual
Action
Printer repeats buzzer
operation in short cycles as
well as display of the
message shown below on
LCD. All LEDs of ROLL
MEDIA, CUT MEDIA,
COLOR and
MONOCHROME also
flash simultaneously.
Transfer failed
Data format error
To stop the buzzer, press
any key except for the
[Power] key once.
To return to status in
which installation is
available, press any key
except for the [Power] key
once again.
Turn the DIP switch
(SW3-2) on the
circuitboard ON, and
perform installation.
When installation is
complete, set the DIP
switch back to its original
position.
Reference
"7.3.5
Firmware
Installation"
p.7-16
"(1) DIP
Switch Settings
on the Main
Board" p.7-16