MUTOH ValueJet 1604 Service Manual page 325

VJ-1604 Maintenance Manual
When connecting the plotter and PC on a one-to-one basis, use "crossover cable". When connecting
the plotter and PC via hub, use "straight cable".
1. Click [Firmware Install].
The "Select of installation file" window is
displayed.
2. Select a file to be transferred from the folder
where the firmware is saved, and click [Open].
Select the install file to be transferred from the
folder where the firmware is stored, and click
[Open].
* Clicking [Cancel] will return to the main
window.
3. In the "Firm installation check" window, click
[OK].
Installation will start.
* Clicking [Cancel] will return to the main
window.
4. The "Communication dialog" window will open.
* If during transfer, it is possible to stop the
transfer by clicking [Cancel].
5. The "Communication dialog" window will open.
7-19
7 Adjustment
Rev.-05