MUTOH ValueJet 1604 Service Manual page 326

7 Adjustment
• When the "Transfer completed" window is displayed, only the transfer of the installation
file from the "MUTOH Maintenance Engineer Assistant" to the printer has completed, and
installation of the program to the printer is still incomplete. Make sure not to turn the
printer power OFF until the installation on the printer side has completed.
• If "Transfer failed incompatible F/W" appears during installation even though the correct
firmware is being installed, refer to the following.
"(1) DIP Switch Settings on the Main Board" p.7-16
(3) Confirming Completion of Installation to Plotter
Program installation to plotter continues even after the "Transfer completed" window is closed. Check
whether the program is properly installed from the operation panel.
1. When firmware transfer starts, the LCD display
on the plotter's operation control panel changes
to [Program receiving].
The Data LED flashes.
2. The LCD display changes as follows:
× × × ×
Erasing ( is numeric)
× × × ×
Copying ( is numeric)
× × × ×
Comparing (
Rev.-05
is numeric)
7-20
VJ-1604 Maintenance Manual