MUTOH ValueJet 1604 Service Manual page 180

4 Parts Replacement
23. Make sure that the distance from the tube clamp area to the tube tip is between 215 and 220 mm.
No.
1
2
The tube arrangement between Maintenance assembly and waste fluid tank has 2
variations depending on the shipment timing. Those procedures are shown below as (1) and
(2).
Confirm the tube arrangement of the printer before removing the tube.
(1) Tube Arrangement A
1. Split the double tube 45mm from the tip of the tube.
No.
1
2. Attach the maintenance assembly to the maintenance base.
Rev.-05
Tube
Maintenance assembly tube
Tube
Part name
Part name
4-130
VJ-1604 Maintenance Manual