Automatically Conserving Energy (Sleep Mode) - Oce CS230 Phase 3 User Manual

3

Automatically conserving energy (sleep mode)

If no operation is performed for a specified length of time, the machine
automatically enters a mode where it conserves energy.
Although the machine conserves more energy in Sleep mode than in Low
Power mode, the machine must warm up when Sleep mode is canceled to
begin printing again, therefore taking more preparation time than Low Power
mode.
As the factory default, the machine enters Sleep mode after 30 minutes.
To recover from Sleep mode
1
Press the [Power Save] key.
2
The machine can receive jobs while it is warming up.
– The touch panel comes on again and, after the machine has
finished warming up, it is ready to begin printing (within 99 seconds
at normal room temperature (23°C)).
Note
The Sleep mode can also be canceled by pressing any key in the control
panel or by touching the touch panel.
!
Detail
As the factory default, the machine enters Low Power mode if no
operation is performed for 15 minutes, and then the machine enters
Sleep mode after 30 minutes have elapsed.
The length of time until the machine enters Sleep mode can be changed.
For details, refer to "System setting" on page 13-28, page 13-39.
3-36
Before making copies
CS230 (Phase 3)