Oce CS230 Phase 3 User Manual page 583

Utility
Parameter
Density
Adjust-
ment
Image Stabilization
Thin Paper Duplex Mode
Color Reg-
istration
Adjust
CS230 (Phase 3)
Description
Thick Pa- Adjust the image density for printing on
per Image thick paper, overhead projector trans-
Density– parencies, or envelopes. The density can
Yellow be adjusted separately for each color
(yellow, magenta, cyan and black for a
Thick Pa-
color image and the black image densi-
per Image
ty). The higher the setting, the darker the
Density–
density.
Magenta
Adjust the setting for yellow, magenta,
cyan and black between –5 and +5.
Thick Pa-
Adjust the setting for "Black Image Den-
per Image
sity" between –2 and +2.
Density–
Cyan
Thick Pa-
per Image
Density–
Black
Black Im-
age Densi-
ty
Perform an image stabilization if the im-
age is incorrect, even after the gradation
levels have been adjusted.
• Image Stabilization Only:
Perform normal image stabilization.
• Initialize + Image Stabilization:
Select when a good result was not
achieved after "Image Stabilization
Only" was selected.
Select whether or not to use this mode
when making double-sided prints on thin
paper. This reduces paper misfeeds
when making double-sided prints on thin
paper.
Color Reg- Adjust the color registration if color shifts
istration can be seen in the print result.
Adjust
(Yellow)
Color Reg-
istration
Adjust
(Magenta)
Color Reg-
istration
Adjust (Cy-
an)
Color Reg-
istration
Adjust
(Black)
13
Default Setting
0
0
0
0
0
–
OFF
–
–
–
–
13-43