5
–
If an automatic system reset operation is performed while the proof
copy for a job is being checked, that job is stored in the memory.
–
If the "System Auto Reset" parameter is set to "OFF", the job is
added to the Held Jobs list after no job is performed for one minute.
–
To stop the proof copy while scanning or printing, perform the
operation described in "Stopping scanning/printing" on
page 4-103.
–
If multiple copies have been specified, another sample copy can be
printed.
–
The number under "Number of Sets" in the Change Setting screen
is the number of copies that will be printed when [Print] is touched.
–
The number under "Number of Sets" in the screen that appeared
when a sample copy is printed indicates the number of copies that
are sample copies/total number of copies specified.
–
The number under "# of Pages" in the screen that appeared when
a sample copy is printed indicates the number of copies that are
sample copies/the number of pages in the sample copy.
8
Touch [Print].
The remaining copies are queued as a copy job.
5-8
Additional copy operations
CS230 (Phase 3)