Oce CS230 Phase 3 User Manual page 106

3
!
Detail
When the control panel is turned on by pressing the auxiliary power
button, the indicator on the [Start] key lights up in orange, and a screen
indicating that the machine is starting up appears.
After a few seconds, the message "Now warming up. Ready to scan."
appears on the touch panel, and the indicator on the [Start] key lights up
in green, indicating that a job can now be queued.
!
Detail
The default settings are those that are selected immediately after the
machine is turned on (the power switch is set to "n") and before any
setting is specified from the control panel or touch panel, and those that
are selected when the [Reset] key is pressed to cancel all settings
specified from the control panel or touch panel. The default settings can
be changed. For details, refer to "Initial setting" on page 13-32.
The factory default settings are the settings that were selected when this
machine was sent from the factory.
Note
A job can also be queued while the machine is warming up after the
auxiliary power button is pressed. For details, refer to "To scan during
warm-up" on page 3-29.
After the machine has finished warming up, the scanned image will be
printed.
The machine takes about 99 seconds to warm up at normal room
temperature (23°C) when the control panel is turned on using the auxiliary
power button after the machine is turned on using the main power switch.
3-28
Before making copies
CS230 (Phase 3)