Oce CS230 Phase 3 User Manual page 157

Basic copy operations
– If the "Print Setting for Separate Scan" parameter is set to "Batch
Print", touch [Finish] in the following screen, which appears while
the document is scanned with the ADF, to continue to step 5.
Scanning begins.
4
Load the next batch of the document, and then press the [Start] key.
– Repeat this step until all pages of the document have been
scanned.
– If the document cannot be loaded into the ADF, place it on the
original glass. For details on the types of documents that can be
loaded into the ADF, refer to "Original documents" on page 8-27.
– The amount of memory available can be checked beside "Memory"
in the upper-right corner of the Basic screen.
– To delete the image data, press the [Stop] key, and then delete the
job. For details, refer to "Stopping scanning/printing" on
page 4-103.
– To change the scanning settings, touch [Change Setting]. For
details on changing the scanning settings, refer to "To change scan
settings for each document" on page 4-37.
CS230 (Phase 3)
4
4-15