Operator Panel Pcb (Leop) - OKIDATA ML590 Service Manual

3.2.09 Operator Panel PCB (LEOP)

Perform these procedures:
3.2.01
3.2.06
3.2.07
1. Cut the nylon tie and release the cable. (Not shown)
2. Disengage the claws (1) on both sides of the frame.
3. Lift the operator panel assembly (2) straight up and remove it.
4. Open eight claws (3) and remove the operator panel PCB (LEOP) (4) from the operator panel
(5).
P/N 53562701 Panel: Operator
Service Guide ML590/ML591
Chapter 3 Maintenance & Disassembly
RSPL Both B.2.02
Page: 101