Rap 11 Serial Interface Problem - OKIDATA ML590 Service Manual

RAP 11 Serial Interface Problem

START.
Are you using a cable with proper number of pins?
No Change the interface cable.
Has the problem been resolved?
Yes End of procedure
No Go to A
Yes
Has the problem been resolved?
Yes End of procedure
No Go to A
No
parity, protocol, busy signal and parity.
Has the problem been resolved?
Yes End of procedure
No Go to A
A
Check the voltages on the main control board.
Is 10 VAC being supplied to the main control board?
Yes Replace the RS232C board.
Has the problem been resolved?
Yes End of procedure.
No Replace the main control board.
Has the problem been resolved?
Is the ALARM LED blinking?
Yes Refer to Section 4.6 of the Service Handbook.
Check the following parameters for the RS232C: baud rate, bit length,
Service Guide ML590/ML591
Chapter 4 Failure & Repair Analysis
Page: 169