OKIDATA ML590 Service Manual page 107

Set the change lever to either the REAR FEED or BOTTOM FEED position.
NOTE:
When the change lever is in the REAR FEED or BOTTOM FEED position, the cut sheet detection
lever does not contact the cut sheet detection switch (BASW) which is located on the main control
board.
Place continuous feed paper in the appropriate tractor.
Press the "FF/LOAD" switch.
The line feed motor will feed the paper until the leading edge of the paper to the top of form
position.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)