3.2.06 Operator Panel Assembly
Perform the procedures listed below first.
- 3.2.01( )
- 3.2.02(
)
- 3.2.04(
)
1) Unlock the four claws (1) and remove the operator panel cover (2).
2) Remove the screw (3).
3) Remove the operator panel board (4).
4) Remove the zebra rubber (5).
5) Remove the LCD element (6).
CAUTION:
If the operator panel or the operator panel cable are not properly attached, the printer
will appear to be completely without power.
A dislodged, cut, or crimped cable will cause apparent initialization problems.
Refer to Section 4 of this Service Handbook for further troubleshooting information.
Service Manual for OL400e/OL410e/OL410e-PS
Chapter 3 Maintenance & Disassembly
Page: 97