Printhead Assembly - OKIDATA ML590 Service Manual

3.2.02 Printhead Assembly

Perform this procedure: 3.2.01 .
1.
2. Open the access cover (1).
3. Lift and remove the ribbon. (Not shown)
4. Pull the head clamp (2) towards the right and then rotate it up to release the printhead (3).
5. Pull the printhead straight up to remove it.
NOTE:
Installation
After installing the printhead, check the printhead gap adjustment.
Service Handbook.
P/N 52106001 Ribbon: Black
P/N 52106002 Ribbon: Color
P/N 50707401 Clamp: Head
P/N 50217201 Assembly: Printhead
Service Guide ML590/ML591
Chapter 3 Maintenance & Disassembly
Consumable Both
Consumable Both
RSPL Both
RSPL Both
Refer to Section 3.3 of this
B.2.09
B.2.09
B.2.06
B.2.02
Page: 94