Rap 04 Paper Jam During Paper Loading - OKIDATA ML590 Service Manual

RAP 04 Paper Jam During Paper Loading

START
Check paper path release lever for proper position. Make sure the paper path is clear.
Which of the following paper jams have occurred?
1. Paper bent at top left corner.
Check the support protector to see if it covers the left side of the paper properly.
Go to A.
2. Paper has torn ends.
Check the ribbon protector.
Check the pull up roller cover to see that it is closed properly.
Go to A.
3. Paper squeezed from either end.
Check around the pressure roller mechanism.
Check the front pressure springs to see that they are mounted properly. There are three
springs in the Microline 590 and five springs in the Microline 591.
Check the tension of all the front pressure rollers to see if they are the same. Top springs:
250 g. Rear Springs: 90 g.
Make sure that the front release gear arm and the gear of the front release gear shaft are
in the proper position.
Go to A.
A
Has the problem been resolved?
Yes End of procedure.
No Check that the head gap is set properly.
Has the problem been resolved?
Yes End of procedure.
Service Guide ML590/ML591
Chapter 4 Failure & Repair Analysis
Page: 162