Removing And Replacing A Riser Board - HP HPE ProLiant DL180 Gen10 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing a riser board

Prerequisites
T-15 Torx screwdriver
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Remove the riser cage.
6. If installed, remove the expansion board from the riser cage.
7. Remove the riser board.
• Primary riser cage
52 Removal and replacement procedures