Table of Contents
Advertisement
To replace the component, reverse the removal procedure.
Removing and replacing an expansion board
Prerequisites
Before you perform this procedure, make sure that you have T-15 Torx screwdriver available.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
Extend the server from the rack.
•
•
Remove the server from the rack.
5. Remove the access panel.
6. If present, disconnect all cables from the expansion board.
7. If replacing the expansion board on the primary riser board, remove the primary riser cage.
8. Remove the expansion board.
•
Primary riser slot 1
Removal and replacement procedures
51
Advertisement
Table of Contents
