2U air baffle
o
Remove the bayonet board assembly
Power down the node (on page 27).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 27).
3.
Place the node on a flat, level surface.
4.
If installed in a 2U node, remove the FlexibleLOM 2U node riser cage assembly
5.
riser cage
If installed in a 2U node, remove the three-slot PCI riser cage assembly
6.
assemblies" on page 46).
If a graphic card/ coprocessor power cable is installed, disconnect it from the bayonet board.
7.
If a B140i SATA cable is installed, disconnect it from the connectors on the system board.
8.
Remove the bayonet board assembly from the node.
9.
assembly" on page 45).
("FlexibleLOM 2U node
("Three-slot PCI riser cage
Removal and replacement procedures 39