Using The Management And Configuration Program; Starting The Management And Configuration Program - IBM BladeCenter Management Module Installation Manual

If you do not want to keep the factory-defined static values, you can configure
the static IP address, host name, and subnet mask for the management module
through the Web interface.

Using the management and configuration program

This section provides instructions for using the management and configuration
program in the active management module.
Note: The sample screens that appear in this document might differ slightly
from the screens displayed by your system. Screen content varies based
on the type of BladeCenter unit that you are using and the firmware
versions and options that are installed.

Starting the management and configuration program

Complete the following steps to start the management and configuration
program:
1. Open a Web browser. In the address or URL field, type the IP address or
host name defined for the management module remote connection (see
"Configuring the management module for remote access" on page 27 for
more details).
The Enter Network Password window opens.
2. Type your user name and password. If you are logging in to the
management module for the first time, you can obtain your user name and
password from your system administrator. All login attempts are
documented in the event log.
Chapter 4. Configuring the management module
29