Section 6 - Adjustments; Leveling Legs - ALLIANCE AE9133 Service Manual

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.

60. LEVELING LEGS

Refer to Figure 37
NOTE: Dryer should be installed on a solid and
level floor. DO NOT install the dryer on a weak or
spongy floor.
a. Place dryer in position, loosen locknuts and
adjust the legs until dryer is level.
b. Keep dryer as close to the floor as possible. All
four legs must rest firmly on the floor so weight
of the dryer is evenly distributed. The dryer
MUST NOT rock.
c. After the dryer has been leveled, tighten the
locknuts securely against the bottom of the
dryer base.
NOTE: If these locknuts are not tight, the dryer will
not stay level during operation.
d. Place a rubber cup (supplied with dryer) under
each of the leveling legs.
60549
Section 6
Adjustments
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
IMPORTANT: DO NOT move the dryer at any time
unless locknuts are securely tightened and the dryer
is completely assembled. DO NOT slide the dryer
across the floor once the leveling legs have been
extended as the legs and base could become
damaged.
RUBBER
CUP
DRYER
BASE
DRY868S
LOCKNUT
LEVELING
LEG
Figure 37
W001R1
55