Symptom: Flashing Display - ALLIANCE AE9133 Service Manual

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.

79. SYMPTOM: FLASHING DISPLAY

NOTE: Refer to Figure 59 to aid in this Troubleshooting section.
Was door open or was the STOP
pad pressed after dryer was
running?
Unplug power cord and check
Unplug power cord and check
outlet for proper polarity and
outlet for proper polarity and
grounding. Refer to .
grounding. Refer to Figure 57.
Polarity and grounding okay?
Remove control hood and
check for loose or incorrect wiring
to terminals "P2" and "P3" on the
control.
Place test meter between
terminals "P2" (door) and "P3"
(neutral) on control.
Approximately 120 Volts between
"P2" and "P3" when door is closed
and "0" Volts when door is open?
Recheck from beginning.
If problem persists, replace
control.
60549
Section 8 Service Procedures Unique to Electronic Control Model Dryers
NO
NO
YES
YES
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Normal operation. Refer to
YES
Operating Instructions.
NO
Contact electrician.
NO
Check door switch and wiring from
door switch to the control.
W001R1
81