Front Panel And Panel Seal; Door Switch - ALLIANCE AE9133 Service Manual

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.

33. FRONT PANEL AND PANEL SEAL

Refer to Figure 12
a. Remove two screws from the bottom edge of
the front panel.
b. Swing the bottom of the panel away from the
dryer to disengage hold-down clips and guide
lugs from cabinet top.
c. Disconnect wires from door switch. Refer to
Figure 13.
NOTE: Refer to the appropriate wiring diagram
when rewiring the switch.
d. Remove front panel seal from flange around
inside of door opening.
NOTE: Be sure seal is properly positioned when
installing on front panel.
HOLD-DOWN
CLIP
GUIDE
LUG
STRIKER
CATCH
ACCESS
DOOR
SCREW
Figure 12
28
FRONT
DOOR
PANEL
SWITCH
SEAL
LOCKNUT
SCREW
DRY1057P
DOOR
HINGE
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING

34. DOOR SWITCH

a. Remove two screws from the bottom edge of
the front panel. Refer to Figure 12.
b. Swing the bottom of the panel away from the
dryer to disengage hold-down clips and guide
lugs from cabinet top. Refer to Figure 12.
c. Disconnect wires from door switch. Refer to
Figure 13.
NOTE: Refer to the appropriate wiring diagram
when rewiring the switch.
d. Depress tabs on top and bottom of switch and
push out of front panel. Refer to Figure 13.
TABS
DOOR
SWITCH
DRY1056S
Figure 13
W001R1
60549