ALLIANCE AE9133 Service Manual page 80

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
LED
Display
99 None (All Off)
88 Wrinkle Free Status
77 Cool Down
66 Drying
55 Clean Filter
44 Memory
33 Damp
22 Normal
11 Extra Dry
00 Very Dry
99 None (All Off)
88 None (All Off)
77 None (All Off)
77 Signal
55 Wrinkle-Free Select
44 No Heat
33 Knits
22 Delicates
11 Perm Press
00 Regular
99 None (All Off)
88 None (All Off)
NOTE:
1. This test routine will only light in the LED's pertaining to the hardware model selected.
2. When the last step in the table is finished, the routine sequence will repeat.
3. East output is on for two seconds.
60549
Section 8 Service Procedures Unique to Electronic Control Model Dryers
Illuminated
LED
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Motor
Relay
On
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
On
Figure 60
Heat Signal
Relay Volume
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Off Softest
Off Medium
Off Loudest
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
On Off
On Off
W001R1
79