ALLIANCE AE9133 Service Manual page 47

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
NOTE: When installing belt, be sure belt is
properly installed on motor and idler pulleys, and is
on the correct side of the idler lever. Refer to
Figure 24. Belt must be positioned around cylinder
between center and rear baffle screws with the
ribbed surface against the cylinder. After installing
belt, rotate cylinder manually to check that belt is
properly aligned.
e. If present, disconnect cylinder light wires.
f. Remove four screws holding bulkhead to front
flange of cabinet. Lift complete bulkhead
assembly out of slots in cabinet. Refer to
Figure 30.
IMPORTANT: During reinstallation of front
bulkhead, be sure that air duct is properly
positioned with the flange inside of the felt seal on
the exhaust fan cover.
g. Loosen two cabinet top hold-down screws.
Refer to Figure 30.
h. Manually rotate cylinder until one of the baffles
is at the 6 o'clock position and carefully remove
cylinder out through front of dryer.
NOTE: On models using unpainted, corrosion
resistant, coated steel cylinder, the cylinder must be
installed with the side marked "FRONT" or the
arrow pointing toward the front of the dryer.
i. Baffles
(1) Remove screws holding baffles to cylinder.
Refer to Figure 32.
IMPORTANT: On models using unpainted,
corrosion resistant, coated steel cylinder, the
elongated baffle must be installed to cover the
cylinder seam weld. Refer to Figure 32.
46
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
BAFFLE
HEX
HEAD
SCREW
SEAM
WELD
ELONGATED
BAFFLE
CYLINDER
HEX
HEAD
SCREW
Figure 32
W001R1
DRY954S
60549