Section 6 -Adjustments; Leveling Legs - ALLIANCE AT050L Service Manual

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.

61. LEVELING LEGS

Refer to Figure 20.
NOTE: It is recommended that the front of the
tumbler be kept slightly higher than the rear
(approximately 1/8 inch, 3.0 mm). This will prevent
the clothes, while tumbling, from wearing on the
door glass gasket.
a. Check the front to rear level by rotating the
clothes cylinder until one of the cylinder ribs is
at the bottom. Place a level on the rib.
b. Check the side to side level by placing a level
on the front and rear of top panel.
NOTE: Keep the tumbler as close to the floor as
possible. All four legs must rest firmly on the floor
so weight of tumbler is evenly distributed. Tumbler
must not rock.
70269301
Section 6
Adjustments
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
T451I
Figure 20
W002
55