ALLIANCE AE9133 Service Manual page 50

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
REAR
BULKHEAD
MOUNTING
BRACKET
QQQQQQQQQ @@@@@@@@@
QQQQQQQQQ @@@@@@@@@
@@@@@@@@@ QQQQQQQQQ
QQQQQQQQQ @@@@@@@@@
@@@@@@@@@ QQQQQQQQQ
QQQQQQQQQ @@@@@@@@@
QQQQQQQQQ @@@@@@@@@
SCREWS
QQQQQQQQQ @@@@@@@@@
@@@@@@@@@ QQQQQQQQQ
@@@@@@@@@ QQQQQQQQQ
HEAT
SCREWS
SHIELD
Figure 34
h. Manually rotate cylinder until one of the baffles
is at the 6 o'clock position and carefully remove
cylinder out through front of dryer.
NOTE: On models using unpainted, corrosion
resistant, coated steel cylinder, the cylinder must be
installed with side marked "FRONT" or the arrow
pointing toward the front of the dryer.
i. Gas Models
(1) Disconnect igniter wires at disconnect
blocks, sensor wires from sensor terminals,
and wires from gas valve coils at the quick
disconnect blocks. Refer to Figure 14.
60549
MOUNTING
BRACKET
QQ QQ @@ @@
QQ QQ @@ @@
SEAL
STRAP
SPRING
DRY864S
HEATER
BOX
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
(2) Remove screw from right side of burner
housing, holding burner tube in place.
Refer to Figure 14.
(3) Gently move burner tube toward rear of
dryer to disengage tab from slot on left side
of burner housing. Refer to Figure 18.
(4) Carefully rotate burner tube and igniter
counterclockwise so tab is at 8 o'clock
position.
(5) Move air shutter end of burner tube slightly
to right and CAREFULLY remove burner
tube and igniter assembly out through front
of dryer.
IMPORTANT: The igniter is very fragile. Be
careful not to damage it during removal.
(6) Remove screw holding burner housing to
heat shroud. Refer to Figure 18.
(7) Remove screw holding front of burner
housing to dryer base and remove housing
out through front of dryer. Refer to
Figure 14.
(8) Remove four screws holding shroud to
heater box and remove shroud out through
front of dryer. Refer to Figure 18.
j. Electric Models
(1) Remove two screws holding heater
assembly to heater box, then pull heater
assembly down and away from heater box.
Refer to Figure 19.
k. Remove screw holding heat shield to dryer
base. Refer to Figure 34.
l. Remove one screw holding rear bulkhead to
terminal block bracket. While supporting
bulkhead, remove the four screws holding rear
bulkhead to mounting brackets, then lift
complete assembly out of dryer. Refer to
Figure 34.
m. To remove heat shield from heater box:
(1) Remove two screws holding heat shield to
heater box. Refer to Figure 34.
n. To remove heater box from rear bulkhead:
(1) Refer to Figure 35 for removal.
Section 5 Service Procedures
W001R1
49