Customizing Programmed Cycles; Time Drying - ALLIANCE AE9133 Service Manual

Section 8 Service Procedures Unique to Electronic Control Model Dryers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
AUTOMATIC CYCLES
REGULAR
Options Temp
Very Dry 150°F
Extra Dry 150°F
Normal 144°F
Damp 135°F

69. CUSTOMIZING PROGRAMMED CYCLES

All automatic cycles can be customized to fit your
laundering needs.
First select a cycle by pressing a SELECT pad.
Then, make changes in the preprogrammed cycle
by using the pads to the right of the STATUS
lights.
The degree of dryness of the load at the end of an
automatic cycle is controlled by the VERY DRY,
EXTRA DRY, NORMAL and DAMP pads. Use
the VERY DRY selection when you want items
extremely dry. Select EXTRA DRY for extra
heavy, bulky items (like blue jeans or towels) that
tend to hold more water than the average load.
Unless another selection is made, the NORMAL
level will automatically be used. Select DAMP for
items that you want to iron or finish drying by
hanging them up. Refer to Figure 51.
The ON/SELECT and NORMAL dryness level
pads work together to provide you with up to nine
different drying temperatures.
68
PERM PRESS
Cool-down Temp
3 min. 144°F
6 min. 144°F
6 min. 144°F
3 min. 120°F
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
DELICATES
Cool-down Temp
8 min. —
10 min. 120°F
10 min. 115°F
8 min. 110°F
Figure 51

70. TIME DRYING

NOTE: The DRYNESS level pads will not work in
the TIME drying cycle.
If you prefer, you can set your dryer to dry the load
for a specific period of time. The dryer will dry
with heat for the number of minutes you have
selected, then tumble the load with room
temperature air for an additional period of cool-
down time.
To TIME DRY the load, first press one of the
ON/SELECT pads. (When the TIME DRY cycles
are used, the ON/SELECT pad controls the drying
temperature to match the selection with the type of
load you are drying.)
Then, press the ON/SELECT pad.You will see
numbers replace the AU in the display area. This
tells you how many minutes of heat have been
selected. The number which automatically
appears is a drying guideline for the type of fabric
that would usually be dried at that particular time
cycle setting.
This time can be increased or decreased by
pressing the MORE or LESS pads. Press MORE
to add drying time to the cycle. Press LESS to
subtract drying time from the cycle. One press of
the pad will change the time in one-minute
intervals. Pressing and holding the pad down will
KNITS
Cool-down Temp
— 145°F
6 min. 145°F
6 min. 140°F
3 min. 130°F
W001R1
Cool-down
8 min.
10 min.
10 min.
8 min.
60549