Cylinder Light; Cylinder Light Receptacle; Cabinet Top - ALLIANCE AE9133 Service Manual

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
EXHAUST HOUSING
ATTACHING SCREWS
Figure 27

48. CYLINDER LIGHT

Open loading door and remove bulb through top
opening in the front bulkhead by turning bulb to
the left. Refer to Figure 28.
CYLINDER
Figure 28
60549
D402S
LIGHT
SCREWS
DRY852S
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING

49. CYLINDER LIGHT RECEPTACLE

a. Remove two screws from the bottom edge of
the front panel. Refer to Figure 12.
b. Swing the bottom of the panel away from the
dryer to disengage hold-down clips and guide
lugs from cabinet top. Refer to Figure 12.
c. Disconnect wires from door switch. Refer to
Figure 13.
NOTE: Refer to the appropriate wiring diagram
when rewiring the switch.
d. Disconnect wires from the light receptacle
terminals.
e. Remove two screws holding receptacle to front
bulkhead. Refer to Figure 28.

50. CABINET TOP

a. Remove two screws from the bottom edge of
the front panel. Refer to Figure 12.
b. Swing the bottom of the panel away from the
dryer to disengage hold-down clips and guide
lugs from cabinet top. Refer to Figure 12.
c. Disconnect wires from door switch. Refer to
Figure 13.
NOTE: Refer to the appropriate wiring diagram
when rewiring the switch.
d. Remove six screws (three top and three bottom)
holding the hood assembly to the control hood
rear panel and cabinet top.
e. Disconnect the wires from all components and
ground wire in control hood, and screw holding
ground wire to top. Push harness down through
opening in cabinet top. (Replace control hood
or set aside to prevent damage.)
NOTE: Refer to the appropriate wiring diagram
when rewiring components.
f. Remove two cabinet top hold-down screws.
Refer to Figure 30.
g. Lift front of cabinet top and disengage from
hinges on rear of cabinet. Refer to Figure 29.
h. Remove control hood rear panel when
replacing cabinet top.
Section 5 Service Procedures
W001R1
43