Front Bulkhead Assembly - ALLIANCE AE9133 Service Manual

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
NOTE: When servicing, cabinet top may be raised
and hinged on the rear hold-down brackets, or
supported against wall behind dryer.
CABINET TOP
Figure 29

51. FRONT BULKHEAD ASSEMBLY

a. Remove two screws from the bottom edge of
the front panel. Refer to Figure 12.
b. Swing the bottom of the panel away from the
dryer to disengage hold-down clips and guide
lugs from cabinet top. Refer to Figure 12.
c. Disconnect wires from door switch. Refer to
Figure 13.
NOTE: Refer to the appropriate wiring diagram
when rewiring the switch.
d. Disengage belt from motor and idler pulleys.
Refer to Figure 24
e. If present, disconnect cylinder light wires.
f. Remove four screws holding bulkhead to front
flange of cabinet and lift complete bulkhead
assembly out of slots in cabinet. Refer to
Figure 30.
44
HINGES
DRY1060S
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
SCREWS
SLOT
NOTE: During reinstallation of front bulkhead, be
sure that air duct is properly positioned with the
flange inside of the felt seal on the exhaust fan cover.
g. Cylinder Glide (Refer to Figure 31)
(1) Remove two screws holding glide to each
glide bracket.
h. Front Cylinder Seal (Refer to Figure 31)
(1) Pull front cylinder seal from under flanged
edge of bulkhead.
(2) Carefully unhook spring from seal strap.
CABINET TOP
HOLD-DOWN SCREWS
DRY858S
CABINET
ATTACHING SCREWS
Figure 30
W001R1
SCREWS
AIR
DUCT
DRY858S
60549