Page 1
Service Manual Automatic Dryers (Model Numbers are listed on Page 5) DR170-SV • October 2017 Part No. D502009R2 JOOuly 1993...
Page 2
A W A R N I NG-----------------------------� Failure to install, maintain, and/or operate this machine according to the manufacturer's instructions may result in conditions which can produce serious injury, death and/or property damage. Do not repair or replace any part of the product or attempt any servicing unless specifically recommended or published in the Parts and Service Manual that you understand and have the skills to carry out.
Table of Contents Nameplate Location ..........4 19. Door Hinge ............18 Model Identification ..........5 20. Hold-Down Clips and Guide Lugs ....18 21. Burner System Components ......19 22. Burner Housing and Heat Shroud ....21 SECTION I - Grounding 23.
Page 4
SECTION IV - Test Procedures 67. Heater Assembly or Burner Repeatedly Cycles Off On Limit Thermostat ....... 59 68. Heater Assembly or Burner Does Not 44. Drive Motor ............44 Shut Off ............60 45. Burner System Operation ......... 47 69.
Namplate Location IMPORTANT When writing for information on any dryer, be sure to mention model and serial numbers. The model and serial numbers will be found on the nameplate in one of i• the four corners of the door well. The door well is the shaded area shown.
Model Identification Information in this manual is applicable to these dryer models: Electronic Cylinder Electric Heat Dryer Models Timer Models Gas Heat Models KEM377-1709 Painted KGM379-1109 Painted Painted AEM477-4562 Painted ZEM477-3000 Painted AGM479-3000 ZGM479-3000 Painted ZGM479-3013 Painted AEM497-3000 Painted AEM497-3300...
SECTION I Grounding AWARNING------------------------------, To reduce the risk of electric shock, fire, explosion, serious injury or death: • Disconnect electric power to the dryer before servicing. • Close gas shut-off valve to gas dryer before servicing. • Never start the dryer with any guards/panels removed. •...
A W ARNING-----------------------------� To reduce the risk of electric shock, fire, explosion, serious injury or death: • Disconnect electric power to the dryer before servicing. • Close gas shut-off valve to gas dryer before servicing. • N ever start the dryer with any guards/panels removed. •...
-· A W ARNING--------------------------------, To reduce the risk of electric shock, fire, explosion, serious injury or death: • Disconnect electric power to the dryer before servicing. • Close gas shut-off valve to gas dryer before servicing. • N ever start the dryer with any guards/panels removed. •...
SECTION II Service Procedures IMPORTANT: When reference to direction (right or left) is made in this manual, it is from the operator's position facing the front of the dryer. A W ARNING-------------------------------, To reduce the risk of electric shock, fire, explosion, serious injury or death: •...
Need help?
Do you have a question about the KEM377-1709 and is the answer not in the manual?
Questions and answers