Kyocera ECOSYS M3040dn Service Manual page 56

Item
Section
No.
FAX U600 Init All Data
U601 Init Keep Data
U603 User Data 1
U604 User Data 2
U605 Clr Data
U610 System Setting 1
U611 System Setting 2
U612 System Setting 3
U620 FAX System
U625 Set Comm
U630 Comm Ctrl 1
U631 Comm Ctrl 2
U632 Comm Ctrl 3
Content of maintenance item
According to the country code and the
OEM code which were inputted, all the
softswitches, backup data, and an image
memory are initialized.
Softswitches other than machine data are
initialized according to the country code
and the OEM code which were inputted.
A circuit class is set up.
The number of times of a bell at the time of
a FAX/TEL automatic change is set up.
All the data of a communication history and
a protocol list is cleared.
The number of waste lines at the time of
degree, the number of waste lines at the
time of automatic reduction, and the num-
ber of waste lines at the time of automatic
reduction (A4, LETTER) are set up.
The number of adjustment lines at the time
of automatic reduction and the number of
adjustment lines at the time of automatic
reduction (A4, LETTER) are set up.
An automatic reduction setup at the time of
receiving a long manuscript is carried out.
The automatic output of a protocol list is
set up.
Remote change mode (a continued type /
one shot type) is set up.
The interval of a redial and the number of
times are set up.
Transmitting start speed and receiving abil-
ity speed are set up.
The measure against an echo at the time
of transmission/reception is set up.
It is set up whether transmission and
reception can be performed in ECM.
The frequency of CED is set up.
It is set up whether sending out after bit33
of a DIS/DTC signal is performed.
The number of times of CNG detection at
the time of a FAX/TEL automatic change is
set up.
1-3-4
2NM/2NX/2NY/2NZ/2P0/2P6
Summary