Kyocera ECOSYS M3040dn Service Manual page 190

Code Contents
2200 Drum motor drive error
(50/60 ppm model only)
The drum motor is not stabi-
lized within 2 s after driving
starts.
2210 Drum motor steady-state
error
(50/60 ppm model only)
Stable OFF is detected for 2 s
continuously after drum motor
stabilized.
2330 Envelope motor error
(Over-current)
(50/60 ppm model only)
The over-current detection
signal of the motor is detected
continuously twenty times.
Related parts
Connector cable or Reinsert the connector. Also check for conti-
poor contact in the nuity within the connector cable. If none,
connector replace the cable.
Drum motor and connect right PWB (YC10)
Connect right PWB and control PWB (YC29)
Drive transmission Check if the rollers and gears rotate
system of the drum smoothly. If not, grease the bushes and
motor gears. Check for broken gears and replace if
any.
Drum motor Replace the drum motor.
Connect right PWB Replace the connect right PWB (see page 2-
2-31).
Control PWB Replace the control PWB and check for cor-
rect operation (see page 2-2-12).
Connector cable or Reinsert the connector. Also check for conti-
poor contact in the nuity within the connector cable. If none,
connector replace the cable.
Drum motor and connect right PWB (YC10)
Connect right PWB and control PWB (YC29)
Drive transmission Check if the rollers and gears rotate
system of the drum smoothly. If not, grease the bushes and
motor gears. Check for broken gears and replace if
any.
Drum motor Replace the drum motor.
Connect right PWB Replace the connect right PWB (see page 2-
2-31).
Control PWB Replace the control PWB and check for cor-
rect operation (see page 2-2-12).
Connector cable or Reinsert the connector. Also check for conti-
poor contact in the nuity within the connector cable. If none,
connector replace the cable.
Envelope motor and connect left PWB
(YC11)
Connect left PWB and control PWB (YC2)
Drive transmission Check if the gears rotate smoothly. If not,
system of the grease the bushes and gears. Check for
envelope motor broken gears and replace if any.
Envelope motor Replace the envelope motor.
Connect left PWB. Replace the connect left PWB (See Page 2-
2-20).
Control PWB Replace the control PWB and check for cor-
rect operation (See Page 2-2-12).
1-4-28
2NM/2NX/2NY/2NZ/2P0/2P6
Check procedures/
corrective measures