Kyocera ECOSYS M3040dn Service Manual page 108

Codes
08 Black band is not detected (DP main scan-
ning direction far end)
09 Black band is not detected (DP main scan-
ning direction near end)
0a Black band is not detected (DP auxiliary
scanning direction leading edge)
0b Black band is not detected (DP auxiliary
scanning direction leading edge original
check)
0c Black band is not detected (DP auxiliary
scanning direction trailing edge)
0d White band is not detected (DP auxiliary
scanning direction trailing edge)
0e DMA time out
0f Auxiliary scanning direction magnification
error
10 Auxiliary scanning direction leading edge
error
11 Auxiliary scanning direction trailing edge
error
12 DP uxiliary scanning direction skew error
13 Maintenance request error
14 Main scanning direction center line error
15 DP main scanning direction skew error
16 Main scanning direction magnification error
17 Service call error
18 DP paper misfeed error
19 PWB replacement error
1a Original error
1b Input gamma adjustment original error
1c Matrix adjustment original error
1d Original for the white reference compensa-
tion coefficient error
Description
1-3-56
2NM/2NX/2NY/2NZ/2P0/2P6-1
Corrective Action
1. Check the attachment position of
DP.
2. Check a lighting of the lamp or
replace.
3. Check the back and front of an
adjustment original.
Turn the power supply OFF/ON and
performed again.
1. Turn the power supply OFF/ON
and performed again.
2. Adjust the below items in manual
operation.
(U065 to U067, U070 to U072)
Turn the power supply OFF/ON and
performed again.
1. Turn the power supply OFF/ON
and performed again.
Adjust the below items in manual
operation.
(U065 to U067, U070 to U072)
Turn the power supply OFF/ON and
performed again.
Set the original correctly and per-
form again.
-
1. Clean the contact glass and slit
glass.
2. Exchange the adjustment origi-
nal.
Set the original correctly and per-
form again.