Kyocera ECOSYS M3040dn Service Manual page 55

Item
Section
No.
Operation U201 Init Touch Panel (HyPAS only)
panel and
support
U203 Chk DP Ope
equipment
U207 Chk Panel Key
U222 Set IC Card Type
Mode set- U250 Mnt Cnt Pre-set
ting
U251 Clr Mnt Cnt
U252 Set Dest
U253 Sel D/S Count
U260 Set Count Mode
U265 Set Model Dest
U285 Set Svc Sts Page
U332 Adj Calc Rate
U339 Chk Drum Heater
U345 Set Mnt Time Disp
U346 Slct Sleep Mode
Image pro- U402 Adjust Margin
cessing
U403 Scan Margin Tbl
U404 Scan Margin DP
U411 Auto Adj Scn
U425 Set Target
Network U520 Set TDRS
Content of maintenance item
It adjusts, when the detection position of
the touch panel has shifted.
Each simulation is operated with DP simple
substance.
An operation key is checked.
Sets the type of IC card.
The preset value (number of sheets) of a
maintenance cycle is set up.
A maintenance counter are displayed and
the data are changed.
The destination is set up.
The copy count methods (double count),
such as a total counter, are set up.
The timing (feeding or ejection) which a
total count etc. count is changed.
The consecutive numbers of the OEM are
set up.
A coverage report output (permission or
failure) is channged.
The coefficient of the fixed form external
application paper to A4 (or 11x8.5) paper is
set up.
The display existence of a drum heater
setup of a system menu is changed.
The number of sheets of a check close dis-
play is set up.
A BAM conformity country is set up.
The space of a leading edge, AC side, and
a trailing edge is adjusted.
The margin of reading data is adjusted by
picture reading by a scanner.
The margin of reading data is adjusted by
picture reading by DP
A scanner and DP are adjusted automati-
cally.
The target value of an adjustment original
is set up.
Perform TDRS settings and information
views.
1-3-3
2NM/2NX/2NY/2NZ/2P0/2P6
Summary