Maintenance Modes Item List - Kyocera ECOSYS M3040dn Service Manual

(2) Maintenance modes item list

Item
Section
No.
General U000 Mainte Report
U001 Exit Mainte
U002 Set Factory Def
U004 Machine No.
U010 Set Mainte ID
U019 Firm Version
Initializa- U021 Init memory
tion
U025 Firm Update(S)
Drive, U034 Adj Paper Timing
paper feed
and paper
conveying
system
Optical U065 Adj Scn
U066 Table Timing
U067 Table Center
U068 DP Scn Start Pos
U070 Adj DP Motor
U071 DP Timing
U072 DP Center
Developer U130 Set Toner Install
U147 Set Toner Apply
Content of maintenance item
It outputs to printing of each report, and
USB.
Maintenance mode is canceled.
A factory-shipments setup (initialization)
and packing mode are set up.
The display of machine serial No. and
serial No. acquired from the engine at the
time of substrate exchange are copied to
MAIN backup.
The brittleness of a security function is pre-
vented by changing ID.
Each soft version is displayed.
The backup data except an adjustment
value is initialized.
Only an administrator can be made to do
FW-UPDATE.
The timing data of leading edge and the
center line adjustment data in a paper stan-
dard are set up.
The degrees of the main and auxiliary
scanning direction at the time of table read-
ing are adjusted.
The timing of leading edge and trailing
edge at the time of table reading are
adjusted.
The position of main scanning direction at
the time of table reading are adjusted.
The timing of starting position at the time of
DP reading are adjusted.
The degree of auxiliary scanning direction
are adjusted by adjusting the speed of time
of DP reading.
The timing of DP reading are adjusted.
The center line of DP reading image are
adjusted.
Installation of a toner is performed.
Same as the above
1-3-2
2NM/2NX/2NY/2NZ/2P0/2P6
Summary