Adjusting Density - Kyocera Mita TASKalfa 250ci Operation Manual

Sending Functions

Adjusting Density

Use the procedure below to adjust the density when scanning the originals.
The table below shows the available settings.
Manual
Auto
The procedure for adjusting the density is explained below.
Ready to send.
Place original.
Density
Auto
Place original.
Lighter
-3 -2
Original : ---
Zoom : 100%
-2.5
Paper : ---
Preview
Add Shortcut
Status
5-20
Item
Adjust density using 7 or 13 levels.
Optimum density is selected according to the
density of the original.
Destination
Normal Darker
-1 0 +1 +2 +3
-1.5 -0.5 +0.5 +1.5 +2.5
Cancel OK
10/10/2008
Detail
1
Press the Send key.
2
Place the originals on the platen.
3
Press [Color/Image Quality] and then [Density].
4
When selecting manual density adjustment, press
[-3] to [+3] (Lighter - Darker) to adjust density.
When selecting auto density adjustment, press
[Auto].
10:10
5
Press [OK].
6
Specify the destination, and press the Start key to
start sending.
OPERATION GUIDE