Network Setup - Kyocera Mita TASKalfa 250ci Operation Manual

Network Setup

The following network settings are available.
• LAN Interface Setup ...8-87
• TCP/IP (IPv4) Setup ...8-87
• TCP/IP (IPv6) Setup ...8-88
• NetWare Setup ...8-90
• AppleTalk Setup ...8-90
• FTP (Transmission) Setup ...8-91
• SMB (Transmission) Setup ...8-91
• Setting of Other Network ...8-93
LAN Interface Setup
Specify the settings for the LAN interface to be used. The default setting is Auto.
Use the procedure below to select the interface.
System - LAN Interface
Select the LAN Interface type.
Auto 10BASE-T 10BASE-T
Half Full
Status
TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network.
Refer to TCP/IP (IPv4) Setup (by Entering IP Addresses) on page 2-10 about the procedures.
OPERATION GUIDE
100BASE-TX 100BASE-TX
Half Full
Cancel OK
10/10/2008 10:10
Default Setting (System Menu)
1
Press the System Menu key.
2
Press [System], [Next] of Network and then
[Change] of LAN Interface.
3
Select [Auto], [10BASE-T Half], [10BASE-T Full],
[100BASE-TX Half] or [100BASE-TX Full] as the
LAN interface.
4
Press [OK].
5
After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-86.
8
8-87