Default Setting (System Menu)
NetWare Setup
Select the NetWare network connection. After that, select frame types for NetWare network from Auto,
Ethernet-II, 802.3, 802.2, or SNAP. The default settings are "On, Frame Type: Auto".
Use the procedure below to setup the NetWare setting.
System - NetWare
Use NetWare to receive documents.
Frame Type
Off
Auto
On
802.3
SNAP
Status
AppleTalk Setup
Select the Apple Talk network connection.
Refer to AppleTalk Setup on page 2-12 about the procedures.
8-90
Ether-II
802.2
Cancel
OK
10/10/2008
10:10
9
After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-86.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then
[Change] of NetWare.
3
Press [On].
4
Press the key for the frame type you want to use.
5
Press [OK].
6
After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-86.
OPERATION GUIDE