Output Destination - Kyocera Mita TASKalfa 250ci Operation Manual

Output Destination

You can use the procedure below to select an output destination such as the optional document finisher for your
copies.
NOTE:
Optional output destinations include the job separator, document finisher, 3,000 sheet document
finisher and mailbox.
The table below shows the available output destinations.
Destination
Top tray
Finisher Tray*
TrayA,TrayB*,TrayC*
Job Separator Tray
Tray1 to 7*
* Copy output orientation can be selected either as face-up (print facing up)
or face-down (print facing down).
NOTE:
To change default destination for copies, refer to Paper Output on page 8-18 for details.
Use the procedure below to select the output destination.
Ready to copy.
Paper Output
Place original.
Top Tray
Tray A
Original : ---
Job Separator Tray 1
Zoom : 100%
Tray
Paper : ---
Tray 4 Tray 5
Preview
Add Shortcut
Status
OPERATION GUIDE
Top tray of the machine (where copies are stored)
Tray of the optional document finisher
Trays A to C in the optional 3,000 sheet document
finisher
Optional job separator
Trays 1 to 7 in the optional mailbox (tray 1 is the top
tray)
1
2
3
4
Copies
Face Up
Face Down
Tray B Tray C
Tray 2 Tray 3
Tray 7
Tray 6
Cancel OK
10/10/2008 10:10
5
6
Description
Press the Copy key.
Place the originals on the platen.
Press [Org./Paper/Finishing] and then [Paper
Output].
Select the output destination for finished copies.
When you select [Finisher Tray], [TrayB], [TrayC] or
[Tray1] to [Tray7], select the orientation of output
copy, Face Up (print facing up) or Face Down (print
facing down).
Press [OK].
Press the Start key to start copying.
Copying Functions
4
4-13