Print Density - Kyocera Mita FS-1800 User Manual

>Print Density
MENU
?
ENTER
ENTER
MENU
Adjusting the Print Density
Density can be adjusted in five steps from 01 (light) to 05 (dark). The
factory setting is 03, and there is normally no need to alter this setting.
When using the KIR function, please use the " 03" setting.
1
Press the MENU key.
2
Press the
or
Print Quality
3
Press the > key.
4
Press the
or
indicates >Print Density.
>Print Density
03
5
Press the ENTER key. The message display shows a blinking
question mark (?).
>Print Density
? 03
6
Press the
or
from 01 (light) to 05 (dark).
If you want to abandon the setting procedure, press the CANCEL
key.
7
Press the ENTER key.
8
Press the MENU key and the message display returns to Ready.
1-75
key and select Print Quality >.
>
key repeatedly until the message display
key and select select the resolution from five steps
Operating the Operator Panel