Continuous Scan - Kyocera Mita TASKalfa 250ci Operation Manual

Continuous Scan

When the multi-page originals cannot be placed in the document processor at one time, the originals can be
scanned in separate batches and then sent as one job. With this function, originals can be scanned one after
another until you press [Scan Finish].
Any of the following settings can be changed during scanning.
• Original Size selection
• Original Orientation
• 1-sided / 2-sided selection
• Scan density
• Image quality
• Scan resolution
• Color selection
• Sending Size selection
• Zoom
• Border Erase
The procedure for using continuous scanning when sending scanned images is explained below.
Ready to send.
Place original.

Continuous Scan

Scan a large number of originals
in separate batches and then produce
as one job.
*Settings can be changed during scanning.
Place original.
Original : ---
Off
Zoom : 100%
Paper : ---
Preview
Add Shortcut
Status
OPERATION GUIDE
1
2
3
Destination
On
Cancel OK
10/10/2008 10:10
4
5
6
7
Press the Send key.
Press [Advanced Setup] and then [Continuous
Scan].
Press [On]. Continuous Scan is selected.
Press [OK].
Specify the destination.
Place the original, and press the Start key.
When the scanning is completed, change the
settings as necessary.
Place the next original, and press the Start key.
Scan the remaining originals by the same
procedure.
When you have scanned all the originals, press
[Finish Scan] to start sending.
Sending Functions
5
5-25