Selecting Copy Size; S Electing Copy Size; To Select Copy Size Automatically (Aps); Density - Kyocera Mita KM-8530 Operation Manual

Selecting Copy Size

To select an appropriate copy size for getting your desired copy result, use APS
(Automatic Paper Selection), or select copy size manually on the touch screen, as
required.

To Select Copy Size Automatically (APS)

APS detects the size of originals placed on the RADF or platen glass and automatically
selects and feeds copy paper of the same size, or selects an appropriate size according
to the magnification ratio selected.
• See the table on the following page for the relation of original size,
• The initial settings may have been altered by Key Operator. See p. 13-
1.
Touch to highlight APS at lower right corner of the Basic Screen.
APS is already highlighted when the initial settings are restored.
2.
Select additional copy conditions, as desired.
3.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
4.
Position original(s).
• See p. 11-8 to p. 11-10 for copy sizes detectable from the RADF or on
• See p. 3-2 to p. 3-6 for details on positioning originals.
• Key Operator can deactivate APS when original is set in the RADF or on
HINTS
magnification ratio and copy paper size.
10 to p. 13-11.
HINT
HINTS
the platen glass.
the platen glass. See p. 13-39 to p. 13-44.
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Copy Size
Lens Mode

Density

1-1, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
DF-630/635
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-11