6.11 CORRECTING THE IMAGES
6.11.1 CORRECTING SKEWED IMAGES
1. Test pattern (Trimming Pattern) mode check
Is the image skewed?
No
Yes
1. Adjust the side fences so that there is no gap between the fences
and paper stack.
2. Adjust the amount of paper buckle: SP1-003-1 and 2.
2. Platen mode check
Set an original flush against the left and rear scales and make a copy.
Does the image come out as a parallelogram?
No
Yes
Attach the Scanner Holder (a supporter normally attached during
shipping)
OR
Perform Procedure A.
3. ADF mode check
Feed an original through the ADF.
Is the image skewed?
No
Yes
Are the front and rear transport rollers feeding the original straight?
No
Yes
Change the position of the right hinge screw to the longer
hole, and make any minor positional adjustments necessary.
Perform Procedure B.
Procedure complete.
SM
CORRECTING THE IMAGES
6-47
B089/B093