Ricoh B089 Service Manual page 329

Downloading NVRAM Data (SP5825)
This downloads data from a flash card to the NVRAM inside the machine.
The following data are not downloaded from the flash card:
• Total count categories (SP7002*** Copy Counter)
• C/O, P/O Counter (SP7006*** C/O, P/O Count Display)
• Duplex, A3/DLT/Over 420 mm, Staple and Scanner application scanning
counters (system settings).
1. Turn off the main switch.
2. Remove the application cover [A].
3. Plug the flash memory card [B] into the card slot.
4. Turn on the main switch.
8. Open SP5825.
5. Touch "Execute" to start download the NVRAM data.
6. Turn off the main switch, then remove the IC card.
Note that the following errors could occur during downloading:
• If a card is not installed in the card slot and a message tells you that downloading
cannot proceed, you cannot execute downloading, even by pressing "Execute"
• If the correct card for the NVRAM data is not inserted in the card slot, after you
press "Execute" a message will tell you that downloading cannot proceed
because the card is abnormal and the execution will halt.
SM
[B]
[A]
4-113
SERVICE PROGRAM MODE
B089S906.WMF
B089/B093