Sp1102 Ifax Switch - Ricoh B089 Service Manual

SP1102 IFAX SWITCH

3.2 SP1102 IFAX SWITCH
Only one SP number is used to access IFAX bit switches. These bit switches are
described in the tables below.
SP IFAX SW
1102 1 00
Bits 0~6: Original Width of TX Attachment File
This setting sets the maximum size of the original that the destination can receive.
(Bits 3~7 are reserved for future use or not used.)
0: On
1: Off
Note: If more than one of these three bits is set to "1", the larger size has priority. For
example, if both Bit 2 and Bit 1 are set to "1" then the maximum size is "A3" (Bit 2).
Bit 6
Reserved
When mail is sent, there is no negotiation with the receiving machine at the
destination, so the sending machine cannot make a selection for the receiving
capabilities (original width setting) of the receiving machine. The original width
selected with this switch is used as the RX machine's original width setting, and the
original is reduced to this size before sending. The default is A4.
If the width selected with this switch is higher than the receiving machine can accept,
the machine detects this and this causes an error.
Bit 7: Not Used.
IFAX
Bit 5 Bit 4
Reserved Reserved
Bit 3 Bit 2
Reserved A3
3-2
Bit 1 Bit 0
B4 A4
SM