Correcting Skew - Ricoh MP 7503SP Field Service Manual

3. Execute a straight-through run.
4. Check the scale where each sheet exits.
• The rear scale is for DLT-size paper.
• The front scale [2] is for A3-size paper.
• Be sure to read the correct scale for the paper size in use.
[A] Centered. No adjustment necessary.
[B] Trailing edge skew to the front, total skew more than ±2 mm. Adjustment required.
[C] Trailing edge skew to the rear, total skew more than ±2 mm. Adjustment required.

Correcting Skew

1. Enter the SP mode and set SP1206 to "2" (OFF).
2. Disconnect the peripheral unit from the upstream unit.
3. Locate and remove the shims from the peripheral unit where the problem occurred.
4. If the peripheral unit is provided with shims, open the front door you will find them attached to the
lower right corner. For example, here is the location for the shims attached to the Multi Fold Unit.
Peripheral Units
1503